Corghi ET 1450 Manual De Uso página 108

PROGRAMME FOR POSITIONING THE
WEIGHTS BEHIND THE SPOKES "HIDDEN
WEIGHT"
For alloy wheels, use the Hidden Weight programme in conjunction with the ALU 1P or ALU
2P programme to conceal the external weight behind two spokes for aesthetic reasons.
The Hidden Weight programme can only be activated if there is an unbalance on the outer side.
This programme divides the outer weight Pe into two weights P1 and P2 located in any po-
sition chosen by the operator. The only condition is that the two weights must be within an
angle of 120° (including the weight Pe), as shown in fig. 23.
Figure 23. Conditions necessary for using the Hidden weights programme
To use this programme, proceed as follows:
1 Turn the wheel until the central element of the corresponding position indicator lights
up
It is recommended to keep the wheel in position using the pedal brake.
2 Press the
Programme activation is indicated by the illumination of the LED
panel.
3 Turn the wheel to the point where the first outer weight (P1) should be applied behind
a spoke. The machine will display the following message:
108
(ONLY WITH ALU1P AND ALU2P
PROGRAMMES)
key to activate the programme.
on the display
Operator's Manual ET 1450