Descargar Imprimir esta página

Kärcher KM 90/60 R P Adv Manual Del Usuario página 18

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 75
1 Operating field
2 Steering wheel
3 Lever for seat adjustment
4 Seat (with seat contact switch)
5 Storage area
6 Holding rail for home base
7 Cover
8 Petrol engine
9 Fuel tank
10 Tank indicator
11 Stop switch
12 Rear wheel
13 Waste container (both sides)
14 Roller brush access
15 Front sealing strip
16 Side sealing strip
17 Rear sealing strip
18 Roller brush
19 Left side brush (optional)
20 Pedal for raising/lowering bulk waste
flap
21 Front wheel
22 Fastener of the side brush
23 Right side brush
24 Drive pedal
25 Wet/dry flap
26 Fuses (behind front panel)
27 Dust filter (flat-fold filter)
28 Maintenance-free batteries
18
Operating and Functional Elements
Operating field
1 Programme switch
2 Operating hour counter
3 Not assigned
4 Horn
5 Ignition key
Before Startup
Open/ close device hood
Danger
Danger of crushing while closing the ma-
chine cover. Hence, lower the machine
cover slowly.
Prior to commissioning, maintenance or
adjustment tasks, the appliance cover must
be opened.
 Grab the front of the appliance cover
and fold it back together with the seat.
 A retaining band keeps the appliance
cover in the rear position.
EN
Danger
Risk of injury, risk of damage!
Observe the weight of the appliance when
you load it!
Do not use a forklift truck to unload the ma-
chine as this may damage it.
Net weight (transport weight)
* If upgrade kits are installed, the weight is
respectively higher.
 Use a suitable ramp or a crane to load
the appliance!
 If the machine is delivered on a pallet,
you must create an unloading ramp us-
ing the boards provided.
To unload the machine, proceed as follows:
 Cut plastic packing belt and remove foil.
 Connect battery (see section on Care
and maintenance)
 Remove the elastic tape fasteners at
the stop points.
 Four indicated floor boards of the pallet
are fastened with screws. Unscrew
these boards.
 Place the boards on the edge of the pal-
let. Place the boards in such a way that
they lie in front of the four wheels of the
machine. Fasten the boards with
screws.
3
-
Unloading tips
265 kg *

Publicidad

loading

Este manual también es adecuado para:

Km 90/60 r p adv carb