Publicidad
1. Coolant reservoir cap
2. Coolant reservoir
1. Bouchon de vase d'expansion
2. Vase d'expansion
1. Tapa del depósito de refrigerante
2. Depósito de refrigerante
3. Bolt (×2)
×
3. Boulon (
2)
3. Perno (×2)
8-49
5. Remove the coolant reservoir by removing
the bolts.
6. Remove the coolant reservoir cap, and
then turn the coolant reservoir upside
down to empty it.
7. After draining the coolant, thoroughly flush
the cooling system with clean tap water.
8. Install the coolant reservoir by installing the
bolts.
9. Replace the coolant drain bolt washer if it
is damaged, and then tighten the coolant
drain bolt to the specified torque.
Tightening torque:
Coolant drain bolt:
10 Nm (1.0 m0kgf)
10. Pour the recommended coolant into the
radiator until it is full.
11. Pour the recommended coolant into the
coolant reservoir to the maximum level
mark.
Publicidad
