HPA-Faip M 624 2V FS Uso Y Mantenimiento página 30

The tyre changer must be transported in its original packing and maintained in the position
shown on the outer packing.
Machine packing dim.:
- width
(cm.)
- depth
(cm.)
- height
(cm.)
Shipping weight (Kg.):
temperature range from -25° to +55°C
Do not stack other goods on top of the packing or damage may result.
To move the packed machine insert the forks of a pallet truck in the channels in the base of the
pallet (Fig. 1).
Before moving the machine refer to the chapter HOISTING AND MOVING.
Keep the packing material intact for possible future transport of the machine.
Take the utmost care when unpacking, assembling, and setting up the machine as
described in this heading.
Failure to observe these instructions can lead to damage to the machine and injury to the
operator or other persons.
Remove the upper part of the packing and make sure that the machine has not suffered
damage in transit; identify the points at which the machine is anchored to the pallet.
The machine comprises two main sections (fig.1):
1. Tower
2. Cabinet
Fig. 2
1) After removing the tower 1, it is advised to place it in a horizontal position to prevent it from
falling and getting damaged.
2) Take off the side cover.
TRANSPORT, STORAGE AND HANDLING
Conditions for transporting the machine
M 624 / M 624 2V
Ambient conditions for storage and transport
WARNING
Handling
ATTENTION
UNPACKING / ASSEMBLY
WARNING
Assembling the head
99
112
102
275
5
M 624 FS / M 624 2V FS
99
112
102
290