HPA-Faip M 624 2V FS Uso Y Mantenimiento página 45

Bead breaker cylinder leaks air around the rod
Air seal worn
- Renew seals
- Renew bead breaker cylinder
Table top will not rotate in one direction or the other
Broken reverser switch
- Replace the reverser switch
Table top will not rotate in either direction
Broken reverser switch
- Replace the reverser switch
Belt broken
- Renew belt
Gear unit broken
- Renew gear unit
Fuse blown
- Change fuse
Table top will not rotate
Motor running irregularly
- Make sure that there are no wires disconnected on the plug, or on the power socket or on the
motor terminal block.
- Renew motor
Gear unit noisy. The table top makes 1/3 of a revolution and then stops
Gear unit seizing
- Renew gear unit
Table top fails to clamp wheels
Table top does not clamp rim
- Renew table top cylinder
Clamp grippers are worn
- Replace locking jaws
Table top mounts or demounts tyres with difficulty
Insufficient belt tension
- Adjust belt tension (Fig.21) or renew it
Vertical slide lifts too little or too far from rim
Clamping plate not adjusted
- Adjust plate (Fig.22)
Vertical slide ascends under strain
Defective clamping plate
- Renew plate
Clamping plate not adjusted
- Adjust plate (Fig.22)
When the tower tilts back, the arm and vertical slide slip to their limit stops
Defective clamping plate
- Renew plate
Clamping plate not adjusted
- Adjust plate
20