HPA-Faip M 624 2V FS Uso Y Mantenimiento página 43

KEEP THE HANDS AND BODY WELL CLEAR OF THE TYRE DURING INFLATION.
ABSOLUTELY NEVER hit the tyre with the lever or other similar tools.
If it is not possible to insert the bead of the tyre and inflate it properly with the setting
values provided, NEVER inflate it on the machine using compressed air lines or any
other external equipment.
Remove the wheel from the tyre changer and repeat the operation using devices
designed to retain both the tyre and any tyre fragments if it should burst, guaranteeing
an appropriate level of safety for the operator (e.g.: an inflation cage).
The unit may be supplied, with a tyre inflation pedal and a pressure gauge for reading the tyre
pressure.
Release the wheel from the sliding clamps on the table top.
Bring the horizontal arm "A" to the fully extended position (Fig. 25c).
Lower the vertical rod "B" until it touches the rim (Fig. 25c).
Lock the horizontal arm and the vertical rod in the positions described above.
Connect the Doyfe inflator chuck (20), on the air hose to the valve stem (Fig. 25c).
Inflate the tyre by exerting pressure a little at a time on the pedal and check the pressure
gauge frequently to make sure that the pressure NEVER exceeds the maximum pressure
specified by the tyre manufacturer.
Inflating tubeless tyres (For M 624 FS and M 624 2V FS models)
Before carrying out the operations described below, always make sure that there is no
dirt, dust or other impurities on the jaws near the air outlet holes.
Make sure that the wheel is secured to the table top with inside clamping.
Connect the Doyfe inflator chuck (20), on the air hose to the valve stem.
Hold the tyre with your hands and lift it until there is a slight gap between the lower bead and
bottom edge of the rim in order to close the upper bead and the top of the rim (Fig. 25).
Press the inflation pedal fully down for a short period to the bead seating position (Fig. 25a).
The tyre will expand and the beads will seat.
Continue to press the pedal in the inflation position (Fig. 25b) until the beads are completely
sealed.
Note: to improve the operation of the tubeless tyre inflation system the compressed air
line pressure must be between 8/10 bar.
On completion of the inflation procedure, check that the beads are correctly positioned
on the rim.
DANGER
DANGER
Inflation (standard version) (All models)
WARNING
WARNING
18