ATIKA BF 43-2 Manual Original página 32

Before each fault clearance:

After each fault clearance, put into operation and recheck all security installations.
Fault
Motor does not start.
Engine starts and is
stalled immediately
Device does not work
with full power
Device works with
interruptions
The brush cutter does not
work with full output
The grass trimmer does
not work with full output
Cutting thread is not
followed up.
Smoke

In case of further faults or inquiries please contact your local dealer.
Please observe the enclosed terms of guarantee.
32
Possible faults
switch off device
−
wait until the cutting device no longer moves
−
pull off the spark plug connector
−
wear gloves
−
Possible cause
 Incorrect starting sequence
 Air filter contaminated
 Fuel filter fouled
 Spark plug fouled
 No fuel supply
 Fault in the fuel line
 Cranking mechanism defective
 Spark plug connector not placed on
 No ignition spark
 Engine flooded.
 Motor defective
 Carburettor defective
 Incorrect idle adjustment
 Machine overloaded.
 Cutting thread too short/broken.
 Device overloaded as grass too high.
 Air filter contaminated
 Carburettor incorrectly adjusted
 Silencer blocked
 Carburettor incorrectly adjusted
 Spark plug fouled
 Cutting blade dull or damaged
 Device overloaded as grass too high
 Cutting thread too short/broken.
 Device overloaded as grass too high.
 No more thread on the spool.
 Cutting thread entangled.
 Incorrect fuel mixture
 Carburettor incorrectly adjusted
Removal
 Observe the correct starting sequence
 Clean or replace the air filter
 Clean or replace the fuel filter
 Clean or replace the spark plug
 Fill the fuel tank.
 Check the fuel line for kinks or damages
 Contact the customer service.
 Screw off, clean and dry the spark plug. Then pull the
cranking rope several times and reinstall the spark
plug
 Place on the spark plug connector.
a) Clean or replace the spark plug.
b) Check the ignition cable.
c) Fault cannot be eliminated?
Contact the customer service
 Contact the customer service
 Contact the customer service
 Contact the customer service
 Do not excessively press during trimming
Follow up the cutting thread.

 Trim the grass in several passes.
 Clean or replace the air filter
 Contact the customer service
 Clean the outlet of the silencer
 Contact the customer service
 Clean or replace the spark plug. Check the spark plug
connector
 Have the cutting blade sharpened or replace it
 Trim the grass in several passes.
Follow up the cutting thread.

 Trim the grass in several passes
 Replace the thread spool.
 Recoil the cutting thread.
 Use two-stroke oil, ratio of mixture 40:1
 Contact the customer service
Guarantee