Angelo Po 1S1PI1G Manual De Uso página 165

HANDLING AND INSTALLATION
WARNING:
tions must be carried out by qualified per-
sonnel with an acknowledged experience in
the specific field, in accordance with the ap-
plicable legislation in the country where the
appliance is installed .
The connection must be carried out with due
care and must comply with all applicable reg-
ulatory and legal requirements .
When the connection is complete and before
the appliance is put into operation, a general
check for any gas leaks is required .
To make the connection, connect the mains line
to the connection pipe of the appliance, fitting a
shut-off tap (A) for the gas supply cut-off when
necessary .
WARNING: The tap (A), which is not
supplied with the appliance, should be in-
stalled in an easily accessible position and
its status (on or off) must be identifiable at
a glance .
IMPORTANT: The connection must
be made in compliance with the relevant ap-
plicable legal requirements, and using ap-
propriate and recommended materials .
IMPORTANT:
The gas supply tap must
open automatically when the
fan of the extraction system
is switched on .
3413940_inst_GB
GAS CONNECTION
The connection opera-
CONNECTION OF FUME EXHAUST VENT
A
A
IMPORTANT: The gas supply pipe
must comply with the national require-
ments in force and must be periodically
checked and replaced if necessary .
HAZARD: Do not connect the appli-
ance to the gas distribution system contain-
ing carbon monoxide or other toxic compo-
nents .
WARNING: The gas feed pipe must
not be longer than 2 metres .
Connection to a fan extractor hood
To carry out this operation, proceed as follows .
Place the appliance underneath the hood (A)
1)
(see figure) .
A
ENGLISH
13