Angelo Po 1S1PI1G Manual De Uso página 169

PART REPLACEMENT
INSTRUCTIONS AND WARNINGS FOR PART REPLACEMENT
NOTE: Read the following section of
the "user instruction manual" carefully be-
fore replacing any part:
– Hazards and safety provisions during instal-
lation and commissioning, adjustments and
part replacement .
WARNING: Before carrying out any re-
placement procedure, activate all the safety
devices provided and decide whether staff
at work and those in the vicinity should be
properly informed . In particular, close the
gas supply tap and prevent access to all de-
To carry out this operation, proceed as follows .
Turn off the gas supply tap .
1)
Open the hatch (A) .
2)
Unscrew the nozzle (B) and replace it with the
3)
one suitable for the gas type being used (see
table at the end of the manual) .
Close the hatch (A) when the operation is
4)
complete .
REPLACING THE BURNER PILOT LIGHT NOZZLE
To carry out this operation, proceed as follows .
Turn off the gas supply tap .
1)
Open the hatch (A) .
2)
Unscrew the union (B) .
3)
Remove the nozzle (C) and replace it with the
4)
one suitable for the gas type being used (see
table at the end of the manual) .
Retighten the union (B) and close the hatch
5)
(A) .
3413940_inst_GB
PART REPLACEMENT
REPLACING THE BURNER NOZZLE
vices which might cause unexpected hazards
and damage to people's health and safety if
activated .
When replacing worn parts, use original
spare parts only . The manufacturer declines
all responsibility for injury or damage to
components resulting from the use of non
original parts, or extraordinary work on the
appliance which may modify the safety re-
quirements without the Manufacturer's au-
thorisation . When ordering components, fol-
low the instructions provided in the spare
part catalogue .
A
A
ENGLISH
B
C
B
17