Luvele LBFD500EU Manual De Instrucciones página 9

INSTRUCTION | P16
Operation
S T E P
Wash Stainless Steel Tray Inserts with warm soapy water or in a dishwasher.
2
S T E P
Do not put the Power Base Unit in water. Wipe down the Power Base Unit
3
with a damp soapy cloth only.
S T E P
Set the Power Base Unit on a level bench top or table.
4
S T E P
Place the Rectangular Drip Tray and the Round Drip Tray into position as
5
shown on page 6.
S T E P
You are now ready to place your food onto each tray. See page 17 for
6
more information about selecting and preparing food for drying.
S T E P
Stack each of the six trays, one on top of each other, onto the Power Base
7
Unit.
NOTE: ALL SIX TRAYS MUST BE USED FOR A DRYING CYCLE.
S T E P
Place the lid on to the sixth tray.
8
S T E P
Plug the power cord into an electrical outlet and you're ready to begin
9
dehydrating your food.
S T E P
Use the Digital Control Panel to set your desired drying temperature and
10
time.
SETTING THE DIGITAL CONTROLS
Once trays are loaded with food and have been stacked, its time
to set the temperature and time for the drying cycle.
SET
Power
Button Button
Press the Power Button once; this will automatically turn on the Dehydrator
S T E P
with the default time setting of 10 hours and the default temperature
1
setting of 50 degrees C.
To adjust the temperature press the SET Button once, the LED temperature
S T E P
display will start to flash, use the Add and Subtract buttons to increase or
2
decrease.
When desired temperature is set, press the SET button again and the LED
S T E P
time display will start to flash. Use the Add and Subtract buttons to set
3
time.
When the time has been selected do not touch any other buttons, the
S T E P
LED display will stop flashing and the time and temperature will
4
automatically be saved.
S T E P
When the digital timer counts down fully, the dehydrator will automatically
5
turn off.
S T E P
To turn off the dehydrator at any time press the Power Button.
6
INSTRUCTION | P17
Operation
Add Subtract
Button Button