Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
I. Start-up problem
1. Using a cutter
1. Normal cylinder
compression.
2. Normal spark from the spark
plug.
3. Problem with the fuel
system.
4. Restricted fuel flow or no
flow
1. Normal cylinder
compression.
2. Normal spark from the spark
plug.
3. Problem with the fuel
system.
4. Easy fuel flow.
PROBLEM
Insufficient amount of fuel in
the tank (tap valve closed)
The vent on the fuel filler cap is
clogged.
The tap valve is clogged.
Primary oil flow is incorrect or
clogged.
The needle valve is not properly
closed or the starter vent is
clogged.
The float is damaged or stuck. Fix the float.
The fuel is too dirty or of poor
quality.
There is water in the fuel.
Too much fuel in the engine.
Wrong fuel brand.
EN
CAUSE
SOLUTION
Add fuel (unscrew the valve)
Open the air vent.
Clean and unclog.
Adjust/clean/unclog.
Disassemble the needle valve
and repair/clean/blow out.
Replace
Replace
Drain an suitable amount of
fuel, dry the spark plug
electrodes
Use the correct brand of fuel
that meets the requirements.
Publicidad
