Kellys E-Bike Instrucciones De Uso página 24

EN
OWNER'S MANUAL
- Before charging, place the battery charger on a flat and stable surface, such as the floor.
- When inserting the adapter into the charging port, hold the charging plug so that it points down
towards the adapter. Do not insert the charging plug into the adapter in the upward direction.
In the case of charging a battery that is installed on the e-bike:
1. Plug the mains plug of the charger into the power supply.
2. Plug the charging plug into the charging port of the battery holder.
- Stabilise the e-bike to make sure it does not fall off while charging.
LABEL
Some of the important information in this manual is also on the battery charger label.
NOTICE
Different chargers are used for Shimano and Kellys re-charge batteries. They differ in the light
indication of charging, charge and errors.
For information on Shimano chargers, visit si.shimano. Follow the combination of the type of charger
and battery used on your e-bike.
Charger for Shimano batteries
When charging starts, the LED indicator on the charger lights up.
Charging
(Within 1 hours after the completion of charging)
Lit up
Charging error
Bliking
Battery disconnected
(1 hours or more after the completion of charging)
Turned off
22
Charger for Kellys Re-charge batteries
Status
Red LED
Inactive Off
Before charging Off
Charging Off
Fully charged Off
Charging error Flashing
To verify that the charger is working properly, plug the charger into the mains. The green LED indicator
starts flashing at a slow rate (charger plugged in but not charging the device). Plug the charger into
the battery. The green LED indicator will continue to flash slowly (battery is charging). When the
battery voltage is less than 25V, the charger will start pre-charging at 500 mA. When the voltage of 25
V is not reached within 30 min. the charger automatically stops charging. In this case, please contact
the place where you bought the e-bike.
When the battery is fully charged, the charger switches off automatically. The green LED stays on
continuously for a short period of time.
SHIMANO SYSTEM
If you use a SHIMANO system on your e-bike, please check and follow this information or information
from si.shimano:
SCREEN/CONTROLLER FUNCTIONS:
Basic on-screen display. Displays the status of the e-bike and trip data. The number of gears and shift
mode are only displayed when using electronic gear shifting.
EBIKE
LED indicator
Green LED
Slow flashing

Flashing

Flashing

On (2 seconds)

Off





