EBIKE
NOTICE
Make sure that the charger is not plugged into the mains during washing.
Regularly clean the e-bike of dirt. Use a brush and lukewarm water for cleaning to prolong its life. Be
careful not to get too much water near the battery. Avoid the accumulation of dirt near the magnetic
sensor (at the transducer on the right side of the e-bike). Do not use high-pressure water cleaners for
cleaning. After each cleaning, dry the e-bike with a soft cloth.
In addition to regular cleaning, you should not neglect regular lubrication of the chain – this will
prevent corrosion and ensure proper operation of the derailleur. We recommend that you request the
appropriate type of lubrication from your dealer.
Products are not covered under warranty if they are subject to natural wear and tear due to standard
use and aging.
ASSIST FORCE
If the setting is not correct, for example if the chain is too tight, the correct assist force may not be
obtained. In this case, please contact the place of purchase.
For any questions regarding handling and maintenance, as well as recommended cleaning and
lubrication products, please contact the place of purchase.
NOTICE
All mechanical components of a e-bike are subject to wear and tear and are subject to high stresses.
Different materials and components can react to wear or fatigue stresses in different ways. If
a component exceeds its design life, it may fail suddenly and cause injury to the rider. Any form of
cracks, grooves or discolouration of highly stressed areas indicates that the component has reached
the end of its service life and should be replaced.
All KELLYS e-bike paints are treated with an appropriate form of UV protection to ensure the highest
possible colour fastness. The method of protection may vary depending on the material on which
the paints are applied. Consumers and customers are cautioned that despite the use of the highest
possible level of UV protection, colours may discolour and/or fade over time. Therefore, do not store
KELLYS e-bikes in places where they will be exposed to direct sunlight and therefore increased
UV radiation. This will prolong the life of the UV protection and keep the colours richer for longer.
A change in colour saturation and possible fading is not a defect of the goods.
When replacing individual parts on your e-bike, use only original components
Have a nice ride
KELLYS
EN
OWNER'S MANUAL
35