Kellys E-Bike Instrucciones De Uso página 29

EBIKE
numerically (the charge drop display will be displayed in 1 % increments)
BUTTONS TO SELECT ASSISTANCE
Use the / buttons to select the level of assist you require. There are 5 levels of assist to choose
from while riding:
[HIGH]: on straight roads and uphill riding, even with heavy loads. It is the most powerful assist mode,
but power consumption is the highest
[AUTO]: a mode in which the system automatically selects between five levels of assist depending on
the condition and profile of the road. Compared to [HIGH] mode, it saves energy.
[STD]: standard mode for riding on straight roads and uphill without heavy loads. It offers balanced
performance and power consumption.
[ECO]: especially for flat and moderate hill riding. It offers the greatest range, but the performance is
lower.
[OFF]: for downhill riding. The assistance is switched off and only the lighting (if the e-bike is equipped
with it) draws energy from the battery.
Button for walk assist
When you are pushing the e-bike, you have the option of using a walk assist. Activate it by pressing
and holding the walk assist button. This function helps at speeds up to 6 km/h.
INFO BUTTON

[SPEED]
It is used to display riding information and system status on the main
[BATTERY]
display.

[RANGE]
[SPEED]: displays the current speed
[BATTERY]: displays the remaining charge level in percentage
[RANGE]: displays the approximate remaining distance with
[AVG]

[MAX] assistance
[AVG]: displays the average speed calculated from the distance
travelled
[TRIP]

[MAX]: displays the maximum speed
[ODO]
[TRIP]: displays the distance travelled since the last reset
[ODO]: displays the total distance travelled
 [CADENCE]
[CADENCE]: displays the crank speed while riding
Resetting the [TRIP], [AVG] and [MAX] values is possible by pressing and holding the information
button until these values change to 0. These values cannot be reset separately.
BASIC SYSTEM SETTINGS
In this section you can change the system language, screen brightness and e-bike settings and also
set the e-bike's electro system to factory settings.
To access the settings display, press and hold the  button and the "info" button at the same time
until the settings screen appears (approximately 3 seconds).
To get back to the main screen, press the night mode button.
• [DISPLAY]
o [BRIGHTNESS]
The screen brightness setting can be selected from 10 levels. You can select separate settings for day
and night mode. The night mode brightness setting can be accessed by pressing the night mode
button.
o [LANGUAGE]
You can choose from the following language options: English, German, Dutch, French, Italian, Spanish,
Danish, Slovak, Polish and Czech
• [BIKE]
o [UNIT]
Used to select speed units: kilometres per hour or miles per hour
o [WHEEL]
Wheel circumference setting. The correct setting of this value depends on the correct functioning
of the speed sensor and the speed and distance measurement. It can be set in the range of 1000 to
2499. This dimension depends on the size of the wheel but also on the thickness of the tyre, so it is
important to adjust these values whenever new tyres have been fitted to an e-bike that do not match
the original specification.
o [ODO]
It is possible to change the total distance travelled. Use the change assist buttons to select a value in
the 10 000 place and the information button to confirm the selected value, and this will display the
EN
OWNER'S MANUAL
27