SICE S 63 E Manual De Instrucciones página 111

Programme activation is indicated by the illumination of the LED
display panel.
3 If the weight-holder device is present, turn the wheel again until the central element
of the outer side (Pe) position indicator lights up
4 Turn the wheel to the point where the first outer weight (P1) should be applied behind
a spoke. The machine will display the following message:
To choose the exact position of weight P1 in relation to the unbalance Pe, use the 6
o'clock point as your reference if "LAS" configuration is active, or the 12 o'clock point
if the "H12" or "CLP" configuration is active.
The angle between P1 and Pe must be less than 120°.
5 press the
6 turn the wheel to the point where the first outer weight (P2) should be applied behind
a spoke. The machine will display the following message:
To choose the exact position of weight P2 in relation to the unbalance Pe, use the 6
o'clock point as your reference if "LAS" configuration is active, or the 12 o'clock point
if the "H12" or "CLP" configuration is active.
The angle between P1 and P2 must be less than 120° and must include the outer
weight Pe.
7 press the
8 turn the wheel manually and the two unbalance values calculated are displayed in
alternation on the display regarding the outer side as the angular position of the wheel
changes. Each of the two balancing weights is applied as described in the chapter
"Applying balancing weights in ALU 1P or ALU 2P balancing programmes".
The Hidden Weight function is combined with the SHIFT PLANES function to allow
the use of balancing weights in multiples of 5 grams
Notes:
- The Hidden Weight procedure can be quit at any time by simply pressing the
.
key
- The Hidden Weight procedure is automatically deactivated by performing a wheel
spin.
Operator's Manual S 63 E - S 63 E C
key to memorise the first spoke.
key to memorise the second spoke
on the
111