Entering Dimensions In The Motorcycle Programmes - SICE S 63 E Manual De Instrucciones

PLAN DETECTION BY SMART-ARM SYSTEM
Geometry data detection for real balancing plans for the ap-
plication of adhesive weights can be facilitated by the laser
line on the automatic detector lever.
To enable this line, it is necessary to press the button on the
automatic arm (A, Fig.20b).
The laser line remains visible inside the rim for 10 seconds,
then, if necessary, press the button on the automatic arm again.
5. ENTERING DIMENSIONS IN THE
MOTORCYCLE PROGRAMMES
The operations described below are valid if the motorcycle setting (bike) has been ac-
tivated in the "vehicle type" set up.
- Fit the appropriate extension on the inner measuring arm, specifically extension A on
machines with no weight holder or extension B on machines with weight holder (Fig.21).
- To acquire the wheel dimensions, follow the instructions in the paragraph "Entering wheel
dimensions".
104
(IF PRESENTED)
21
S 63 E - S 63 E C Operator's Manual
20b