Other Messages - SICE S 63 E Manual De Instrucciones

• use the
• press the
E 27 Excessive braking time. If the problem persists, contact the technical sup-
port centre.
E 28 Encoder counting error. If the error occurs frequently, call in the technical sup-
port centre.
E 30 Wheel spin device failure. Switch off the machine and call in the technical
support centre.
E 32
The wheel balancer has been jolted during the reading phase. Repeat the
wheel spin.
E F0 Error in reading the 0 notch.
- This message indicates the valve of the wheel that must be brought to
OP.1
- This message indicates that the position of the valve must be moved 180°
OP.2 180
- This message is displayed when the improvement obtained by optimisa-
Out 2
- Press the
- Notice PREMATURE EXIT from the unbalance optimisation program
Abo rt
- Press the
- Notice TYRE MOUNTING INVERSION ON THE RIM in the OP.5 phase of
--I- -I--
If you do not want to (or cannot) carry out this operation, press the
key. the machine will provide the instructions to complete the programme
without inversion.
- This message indicates that the operator is in the "positioning the weights
HId dEn
Operator's Manual S 63 E - S 63 E C
key

19. OTHER MESSAGES

the 12 o'clock position during phases 1 and 5 of optimisation (OPt)
with respect to the previous position (12 o'clock)
tion is not sufficient
key to exit the program or the
the optimisation phase.
key to confirm or the
programme
the programme.
behind the spokes Hidden Weight" programme
keys to search for GAU CAL
key to continue
key to remain in the
131