SICE S 63 E Manual De Instrucciones página 114

- turn the wheel until it is in the position shown by the position indicators.
- use chalk to make a double mark on the outer side of the tyre at the
12 o'clock position
Note: in this phase, press the
key is pressed, the actual unbalance values of the wheel as currently
mounted on the wheel balancer; the second time the key is pressed,
the obtained unbalance value continuing with the last phase of the op-
timisation procedure with the improvement percentage; when the key
OP.5
is pressed for the third time, the machine prepares for the last phase
of the OPT programme
- remove the wheel from the wheel balancer
- on the tyre changer, move the double mark made in correspondence
with the valve
- press the
procedure.
Notes:
- The unbalance optimisation procedure can be quit at any time by pressing the
key; the displays will show the premature exit message:
Press the key to exit or the
- The following message could be displayed at the end of the first spin:
In this case it is advisable to exit the programme by pressing the key
of the weights necessary for balancing the wheel are displayed. The programme execu-
tion is interrupted, thus not achieving the moderate improvement of the end results.
114
OPERATING PHASES
key to confirm and end the unbalance optimisation
key to stay in the programme.
Out
key to display: the first time the
2
S 63 E - S 63 E C Operator's Manual
the values