Optimisation Programme "Opt - SICE S 63 E Manual De Instrucciones

12. OPTIMISATION PROGRAMME "OPT"

This procedure minimises any vibration still present on the vehicle while running even
after accurate balancing, thus minimising the rim-tyre coupling run-out.
Based on our experiences, the programme can be recalled every time it is convenient to
minimise the running noise produced by the vibrations mentioned above.
The calculations performed by this programme are based on the unbalance values measured
during the last spin performed which must therefore refer to the wheel being serviced.
• Press the
• use the
• press the
Programme activation is indicated by the illumination of the LED
panel.
OP.1 H.12
- bring the valve to the "12 o'clock" position and press
confirm
- make a mark on the tyre 180° from the valve
- remove the wheel from the wheel balancer
- go to the tyre changer and move the mark made in correspondence
OP.2 180
with the valve
- press the
- Remount the wheel on the wheel balancer;
- Move the valve to the 12 o'clock position;
OP.3 H.12
- press the
OP.4
- perform a spin
Operator's Manual S 63 E - S 63 E C
key.
keys to search for OPt
key to activate the optimisation procedure
OPERATING PHASES
key to confirm.
key to confirm
on the display
to
113