Entering Wheel Dimensions (Except For Alu 1P And Alu 2P Programmes) - SICE S 63 E Manual De Instrucciones

Vehicle
type
STA
ALU 1
ALU 2
dyn
BIKE
ALU
BIKE
*The machine allows the operator to change the application position of the adhesive
weight from 12 o'clock (via the CLIP weight-holder) to 6 o'clock (via the laser line), de-
pending on his requirements.
To change the application position for the adhesive weights, follow the instructions in
the set up menu "Adhesive weight application position".
3. ENTERING WHEEL DIMENSIONS
(EXCEPT FOR ALU 1P AND ALU 2P
PROGRAMMES)
Wheel data entry for wheel
balancers without an ultrasonic
sensor
The machine allows for the diameter and
distance values to be entered automati-
cally; the width value can be entered using
the keypad.
- Bring the automatic measuring arm into
contact with the inner side of the rim (fig.16).
Take great care to position the arm correctly
so as to ensure accurate data reading.
While moving the automatic arm, the dis-
96
Balancing
programme
Adhesive weight to ap-
ply manually at the 12*
Inner weight applica-
tion type and mode
spring weight or adhesive weight to be applied
manually at the 12 o'clock position either on the
outer or inner side or at the centre of the rim
well clip weight to be applied manually at the 12
o'clock position
ply manually at the
12* o'clock position
clip weight to apply
manually at the 12
o'clock position
clip weight to apply
manually at the 12
o'clock position
adhesive weight to ap-
o'clock position.
S 63 E - S 63 E C Operator's Manual
External weight appli-
cation type and mode
Adhesive weight to ap-
ply manually at the
12* o'clock position
Adhesive weight to ap-
ply manually at the 12*
o'clock position.
clip weight to apply
manually at the 12
o'clock position
adhesive weight to ap-
ply manually at the 12*
o'clock position.
16