Display Panel - Control Keypad - SICE S 63 E Manual De Instrucciones

DISPLAY PANEL - CONTROL KEYPAD

KEY
1
2
3
4
5
6
7
Operator's Manual S 63 E - S 63 E C
- Press this key to manually enter the wheel dimen-
Wheel dimen-
sions
Multifunction key
1. in balancing mode, press this key to temporarily
End / Esc
2. in a menu or in a program, press this key to exit.
3. holding the key down for at least six seconds,
Multifunction key
1. in balancing mode, press this key to select the
Internal weight
selection/
2. in the menu press this key to navigate.
Decrease
3. when entering dimensions manually, press this
Multifunction key
1. in balancing mode, press this key to access the
Menu / Enter
2. in a menu or in a program, press this key to
Multifunction key
1. in balancing mode, press this key to select the
Outer weight
selection/In-
2. in the menu press this key to navigate.
crease
3. when entering dimensions manually, press this
- Press this key to perform a spin with the wheel
Start
- Search for another side (with RPA active and
Stop - Press this key to stop the spin
DESCRIPTION
sions in the case of an automatic measurement
system malfunction or for versions with a manual
internal sensor.
display the value rounded to the gram or 1/10 of
ounce.
Note: for ALU 1P and ALU 2P balancing programs
with shift plane, this key is not enabled.
the machine performs the conversion of units
from grams to ounces.
type of weight to use on the inner side of the wheel.
key to decrease the displayed value.
wheel balancer menu.
change the viewed option.
type of weight to use on the outer side of the wheel.
key to increase the displayed value.
guard lowered
wheel guard open)
91