Set Up - Laser Indicator - SICE S 63 E Manual De Instrucciones

or LEd 1 to activate the lighting device when acquiring dimensions during an ALU1
P or ALU2 P balancing programme, at the end of a spin cycle in the case
of residual unbalances for 30 seconds, in CP (centred position) for an ad-
ditional 30 seconds
or LEd 2 in this configuration, the light will turn on, in addition to the situations indi-
cated above (in the Led1 mode) also during the entire measurement cycle,
when acquiring dimensions in all balancing programmes and in the Hidden
Weight programme when selecting the two planes behind the spokes.
- press the

15.12. SET UP - LASER INDICATOR

The machine allows the operator to enable or disable the laser device.
Proceed as follows to make this setting:
- Press the
- use the
- press the
- use the
- press the
or LAS on to enable the laser device
or LAS oFF to disable the laser device
- press the
Caution
If the laser indicator is enabled, the application of the adhesive weights (except for the ALU1
P and ALU2 P balancing programs with the weight-holder device present) and the refer-
ence for selecting the two weights behind the spokes (Hidden Weight) is at 6 o'clock (H.6).
126
key to confirm and exit.
key.
keys to search for SEt UP
key to confirm
keys to search for LAS on (LAS oFF if previously set)
key to change the setting:
key to confirm and exit.
S 63 E - S 63 E C Operator's Manual