SICE S 63 E Manual De Instrucciones página 78

the groove on the pivot is
aligned with the pin in the
bush;
- Fasten the tube on the
pivot using the M12 screw
supplied.
- Insert the metal tube (D,
Fig. 4a) into the two plastic
guard front holes (C, Fig.
4a);
- Couple the guard to the
rear side of the tube by
inserting it into the cor-
rect position with snap-in
coupling (E, Fig. 4a);
- Secure the wheel guard
by tightening the screw
provided (F, Fig. 4a).
Assembly of the ultrasonic sensor and its "optional accessory
supplied on request" support for automatic width measurement
- insert the ultrasonic sensor cable in the slots on the metal pipe (see fig.5),
- fasten the ultrasonic sensor support to the guard pipe using the three M8 screws pro-
vided (fig. 5a);
- connect the sensor cable to the connector
on the side of the casing (A, fig.6)
- Adjust the length of the ultrasonic sensor
cable near the connector (A, fig.6) with a
closed guard, to avoid the deformation of
the connector itself during handling of the
wheel guard.
- Then lock the cable through the supplied
strap (A, fig.5). Any excess cable in the
object will be inserted and locked (by
means of the bases already present) inside
the sensor support. To access inside the
sensor stand, remove the plastic cover by
unscrewing the four fixing screws (Fig. 6a).
78 S 63 E - S 63 E C Operator's Manual
4a
5