Balancing Programme Selection - SICE S 63 E Manual De Instrucciones

2. BALANCING PROGRAMME SELECTION

Before starting a balancing operation, the following steps must be followed:
- fit the wheel on the hub using the most suitable flange;
- lock the wheel so that no movement is possible during the wheel spin and braking phases;
- remove any counterweight, pebble, dirt or other foreign body;
- set the wheel's geometric data correctly.
At start-up, by default, the wheel balancer executes the dynamic programme (dyn) which
uses clip weights on both sides.
The various balancing programmes can be recalled by simply selecting the keys
that represent the type of weight according to the rim and professional experi-
ence, both for the inner side as well as for the outer side.
The following balancing programmes are available:
Vehicle
type
dyn
ALU
1P
ALU
2P
ALU 3
ALU 4
ALU 5
Operator's Manual S 63 E - S 63 E C
Balancing
programme
Adhesive weight to ap-
ply manually at the 12*
ply manually at the 12*
Inner weight applica-
tion type and mode
clip weight to apply
manually at the 12
o'clock position
ply manually at the
12* o'clock position or
using weight holder if
present
clip weight to apply
manually at the 12
o'clock position.
adhesive weight to ap-
o'clock position.
clip weight to apply
manually at the 12
o'clock position
adhesive weight to ap-
o'clock position.
External weight appli-
cation type and mode
clip weight to apply
manually at the 12
o'clock position
adhesive weight to ap-
ply manually at the
12* o'clock position or
using weight holder if
present
adhesive weight to ap-
ply manually at the
12* o'clock position or
using weight holder if
present.
adhesive weight to ap-
ply manually at the
12* o'clock position
adhesive weight to ap-
ply manually at the 12*
o'clock position.
clip weight to apply
manually at the 12
o'clock position
95