Wheel Spin Counter; General Configurations - Set Up - SICE S 63 E Manual De Instrucciones

14. WHEEL SPIN COUNTER

This programme is used to display the total number of spins performed by the machine since its
first start-up (tot SPi), the number of spins performed since the last unbalance calibration (CAL
SPi) and the number of partial spins performed since the machine was last started (PAr SPi).
Proceed as follows to recall this programme:
• press the
• use the
• Press the
its first start-up (tot SPi)
• Press the
calibration (CAL SPi). It is reset at each new calibration.
• Press the
calibration (PAr SPi). It is reset each time it is turned off.
• press the

15. GENERAL CONFIGURATIONS - SET UP

The machine can be configured according to your requirements. The following configurations
are available:
- Selecting vehicle type (car – motorcycle)
- Unbalance unit of measurement
- Unbalance rounding-off
- Automatic search for RPA position
- Warning OPT
- Rim diameter display unit of measurement
- Rim width display unit of measurement
- Beeper
- Setting - Application position for adhesive weights
- Display brightness setting
- LED light
- Laser indicator
116
key
keys to search for -SP in-
key to display the total number of spins performed by the machine since
key to display the number of spins performed since the last sensitivity
key to display the number of spins performed since the last sensitivity
key to exit.
S 63 E - S 63 E C Operator's Manual