SICE S 63 E Manual De Instrucciones página 130

Wheel movement is not integral with swinging unit movement: Check correct
wheel tightening.
A Cr Spin performed with the guard raised.
Lower the guard to perform the wheel spin.
In machine versions with a start button, either the START key or the button
released during the spin.
Perform the spin holding down both the START key as well as the button.
E 1 Absence of sensitivity calibration.
Perform the sensitivity calibration procedure.
E 2 Error condition during sensitivity calibration.
Repeat sensitivity calibration paying attention to the first spin, which must be
performed with the wheel as in the successive spins.
Take particular care NOT to knock the machine during calibration.
E 3 I/E 2/3 Error condition at the end of sensitivity calibration. Repeat the calibration, if
the message persists perform the following checks:
Correct sensitivity calibration procedure;
Correct fastening and position of the calibration weight;
Mechanical and geometric condition of the calibration weight;
geometry of the wheel used.
E 4 a) Error condition on ultrasonic sensor calibration. Calibrate the ultrasonic
sensor.
b) ultrasonic sensor not present. Visualisation of this error can be disabled by
performing the following procedure:
• press the
• use the
• press the
E 6 Error condition when executing optimisation programme.
Repeat the procedure from the beginning.
E 12 Ultrasonic width sensor not present, or faulty. Visualisation of this error can
be disabled by performing the following procedure:
• press the
130
– E – Error messages
key
keys to search for GAU CAL
key
key
S 63 E - S 63 E C Operator's Manual