SICE S 63 E Manual De Instrucciones página 93

Centring with flanges
Removing the C hub
- Insert the special C key (supplied with the machine) in the slot of the C hub (fig.12);
- Completely unscrew the C hub;
- Mount the flange on the shaft and lock it in place with the two screws (A, fig.13) using the CH
6 wrench.
- Lock the wheel onto the flange as usual.
Assembling the C hub
To reassemble the C hub, proceed as follows:
- insert the split pin (supplied with the machine) in the cylindrical protection bush (B, fig.14)
- Pull the split pin as per picture 14 then screw the C hub manually until it reaches the end
position.
Operator's Manual S 63 E - S 63 E C
A
12
13
14
93