SICE S 63 E Manual De Instrucciones página 132

no no
- This message is displayed if the wheel is balanced on the outer side
- This message indicates that the machine is set for acquiring the P1 posi-
in -1-
- This message indicates that the machine is set for acquiring the P2 posi-
in -2-
- This message is displayed for approx. 3 seconds if the selected angle is
no -2-
- This message indicates the reference for acquiring the two points P1
in H.X
CAL GO
- Calibration spin
- This message indicates the correct position for applying the calibration
I - - CAL
- This message indicates the correct position for applying the calibration
-- I CAL
End CAL
- This message indicates the end of the unbalance calibration programme
GO ALU
- Spin with ALU programme selected
GO d15
- Spin with Motorcycle Dynamic programme selected
GO A15
- Spin with Motorcycle ALU programme selected
- Spin with Static programme selected (car/motorcycle environment) or
St
- This message indicates the selection of the Static balancing programme
St biE
- This message indicates the selection of the dynamic balancing programme
dyn biE
- This message indicates the selection of the ALU balancing programme in
ALU biE
ccc ccc
- Unbalance values greater than 999 grams
- This message indicates the Inner Plane for applying the adhesive weight
-1A
- This message indicates the External Plane for applying the adhesive
A-2 ---
132
tion behind the first spoke
tion behind the second spoke
greater than 120 degrees, indicating that the procedure must be repeated
correctly
and P2 behind the spokes. Depending on the configuration made by
the operator, the message shown on the right-hand display may be H3,
H6 or H12. If the laser indicator is enabled, the reference is the 6 o'clock
position (H.6)
weight in the unbalance calibration programme at the end of the first spin
weight in the unbalance calibration programme at the end of the second
spin
when the Static balancing programme is selected in the vehicle working
environment
in the motorcycle working environment
in the motorcycle working environment
the motorcycle working environment
in the ALU 1P balancing programme
weight in the ALU 1P/ALU 2P balancing programme
S 63 E - S 63 E C Operator's Manual