SICE S 63 E Manual De Instrucciones página 98

- if only one measurement is taken, the ma-
chine interprets the presence of a rim with
balancing using a clip weight on both sides
(Dynamic Balancing Programme)
- moving the arm to the rest position, the ma-
chine will set up for the manual WIDTH entry.
- in this phase, it is possible to perform an
additional acquisition of the rim diameter
and distance.
- Measure the width of the rim using the pro-
vided calliper (fig. 17).
- Modify the width value displayed by pressing
the
value is set.
The WIDTH can be set in millimetres or the values already set can be converted from inches
to millimetres by pressing the
98
keys until the desired
button.
S 63 E - S 63 E C Operator's Manual
16b
17