SICE S 63 E Manual De Instrucciones página 77

WARNING
For information concerning the techni-
cal features, warnings and maintenance
instructions consult the related operator
manuals provided with the documentation
of the machine.
CAUTION
The machine must not be operated in po-
tentially explosive atmospheres.
The machine is supplied partially disassem-
bled and is to be assembled according to the
procedures described below.
Head assembly (fig.3/3a)
- Remove the head rear closing plate (C,
Fig.3);
- Loosen the 4 screws M8 (A, Fig.3) that fasten
the head to the body on the rear side without
unscrewing them completely;
- Remove the head from the 4 fastening
screws pulling them first towards the left
and then towards the rear side of the
machine;
- Turn the head to a vertical position and
insert the 4 fastening holes on the M8 screws
on the body (B, Fig.3a), making sure that the
previous loosened screws do NOT touch the
head itself;
Operator's Manual S 63 E - S 63 E C
- Tighten the fastening screws on which the
head is positioned;
- Fit the previously removed head closing
plate.
Installing the wheel guard with the
corresponding mounting (Fig. 4)
- Install the bush (A, fig. 4) on the rotation
4
pivot (B, fig. 4). While doing this, ensure that
3
3a
77