TOHATSU M 40D2 Manual Del Propietário página 29

ENOM00830-C
Mounting bolts
Manual tilt type
1. To attach the outboard motor to the
boat, tighten the clamp screws by
turning their handles.
Also, use the bolts to secure the out-
board motor brackets on transom
board.
Secure the outboard motor with a rope
to prevent loss overboard.
ENON00002-0
Note
A rope is not included in the standard
accessories.
2
4
1. Clamp Screw
2. Washer (small diameter)
3. Washer (large diameter)
4. Bolt (12 mm × length 105 mm)
5. Nut
1. Top of transom
Power trim and tilt type
1. To attach the outboard motor to the
boat, use the bolts to secure the out-
board motor brackets on transom
board.
1
3
5
ENOF00610-0
1. Bolt (12 mm × length 105 mm)
2. Washer (large diameter)
3. Washer (small diameter)
4. Nut
INSTALLATION
234 (9.21")
117 (4.61") 117 (4.61")
25 (0.98")
25 (0.98")
ø13
204 (8.03")
102 (4.02") 102 (4.02")
ø13
26 (1.02")
1
3
27
1
39 (1.54")
64 (2.52")
89 (3.50")
222 (8.74")
248 (9.76")
ENOF00611-0
5
2
4
ENOF00612-1