TOHATSU M 40D2 Manual Del Propietário página 37

2
Pour engine oil into fuel container, and
then, gasoline.
3
Put cap on the container, and close
tightly.
4
Shake the container to mix engine oil
and gasoline well and even.
5
Pour the mixture into fuel tank.
ENON00922-0-0
Notes
It is recommended to pre-mix by using
separate fuel container. Attempting to
pre-mix in the fuel tank built-in the boat
can make the mixture uneven.
If built-in fuel tank is used for mixing,
pour engine oil into the tank little by little
while putting gasoline into the tank.
ENOM01661-0
Auto mixing type
ENOW00604-0
CAUTION
In the unlikely event that gasoline by
mistake is filled into the oil tank, drain
the oil tank completely, and consult an
authorized service shop for advice.
Check the amount of oil in the oil tank
visually before starting the engine. Run-
ning out of oil at sea is a cause for
potential disaster.
The required amount of engine oil is auto-
matically supplied from the oil tank,
through the oil pump, according to the
engine running conditions. Gasoline is fed
over a separate feeding line.
PRE-OPERATING PREPARATIONS
During break-in
Add engine oil into fuel tank. The mixing
ratio with gasoline during break-in is 50:1
(50 parts oil and one part gasoline). Mix
well by hand.
During break-in
ENOM00644-1
Replenishing oil in the engine oil tank.
1. Open the filler lid from the top cowl.
2. Open the oil tank cap.
3. Fill the oil tank with the genuine engine
oil.
4. After replenishment of the oil tank, be
sure to close the oil tank cap tightly.
1
3
1. Genuine of recommended engine oil
2. Filler lid
3. Oil tank cap
Gasoline : Engine Oil
50 : 1
2
ENOF01963-0
35
6