Daily Inspection - TOHATSU M 40D2 Manual Del Propietário

66
INSPECTION AND MAINTENANCE
ENOM01664-0

1. Daily Inspection

Perform the following checks before and
after use.
Item
Fuel System
Lubrication
System
Electrical
Equipment
Throttle System
10
Recoil Starter
Clutch and
Propeller System
Installation of
Motor
Power Trim & Tilt
Cooling Water
Tools and
Spares
Steering Devices
Other Parts
Points to Check
• Check the amount of fuel in the tank.
• Check for dust or water in the fuel filter.
• Check rubber pipes for oil leakage.
• Check the amount of engine oil in the oil tank.
• Check for dust or water in the oil filters.
• Check the spark plugs for dirt, wear and carbon built-up.
Spark plugs 40D2 : NGK B-7HS-10/NGK BR-7HS-10
Spark plugs 50D2 : NGK B-8HS-10/NGK BR-8HS-10
• Check if the main switch functions normally.
• Check if the battery electrolyte level and specific gravity are normal.
• Check for loose connections on battery terminal.
• Check if the emergency stop switch functions normally and
make sure the lock plate is present.
• Check cords for loose connections and damage.
• Check if the choke solenoid and valve for the carburetor works
normally.
• Check if the carburetor and magneto work normally when
turning the throttle grip, and also check links for looseness.
• Check ropes for wear and damage.
• Check the ratchet for engagement.
• Check if the clutch engages correctly when operating the
Remote Control.
• Check the propeller for bent or damaged blades.
• Check if the propeller nut is tightened and the split pin is present.
• Check all the motor installation bolts with the boat.
• Check the thrust rod installation.
• Check working of the tilt up and down of the motor.
• Check that cooling water is discharged from the cooling water
check port after the engine has started.
• To be ready tools and spare parts for replacing spark plugs,
propeller, etc.
• Check if the spare rope is provided.
• Check working of steering handle and remote control.
• Check if the anode and trim tab are securely installed.
• Check the anode and trim tab for corrosion and deformation.
ENOW00078-0
WARNING
Do not use outboard motor if any abnor-
mality is found during pre-operation check
or it could result in severe damage to the
motor or severe personal injury.
Action
Replenish
Clean
Replace *1
Replenish
Clean
Clean or replace
Remedy or replace *1
Replenish or recharge
Retighten
Remedy or replace *1
Correct or replace *1
Replace *1
Correct *1
Replace *1
Correct or replace *1
Adjust *1
Replace
Tighten
Tighten
Repair if necessary
Replace