TOHATSU M 40D2 Manual Del Propietário página 36

34
PRE-OPERATING PREPARATIONS
Pre-mixing type
Add engine oil into fuel oil tank. The mixing
ratio with gasoline is 50 : 1 (50 parts gaso-
line and one part oil). Mix well by hand.
The mixing ratio during break-in running is
25 : 1.
During break-in
After break-in
Fuel by Oil Mixing (25:1, 50:1)
Oil
1.0L
6
0.5L
0.4L
0.2L
0
2L
ENOM01003-0
Engine oil – gasoline mixing
procedure
ENOW00937-0
Do not use other than two stroke engine
oil with specified grade, or the engine
may be damaged.
Do not use fuel prepared in other than
specified mixing ratio.
- Lack of engine oil can cause severe
engine trouble such as piston seizure.
- Excess of engine oil can shorten spark
plug life, and/or cause increase of nox-
ious exhaust.
For quantities of engine oil and gasoline to
be pre-mixed, refer to table in previous
page.
Mixing Ratio
Engine Oil : Gasoline
25 : 1
50 : 1
(25:1)
25 : 1
(25:0.5)
(10 :0.4)
50 : 1
(10 :0.2)
10L 25L
Gasoline
ENOF01708-0
CAUTION
When portable fuel tank is used for
operation of outboard motor(s):
1
Pour engine oil into fuel tank, and then,
gasoline.
2
Put cap on the tank, and close tightly.
3
Close air vent plug tightly.
ENOW00938-0
Loose cap or air vent plug can cause leak
of fuel during shaking the tank.
4
Shake the tank to mix engine oil and
gasoline well and even.
When fuel tank built in the boat is
used for operation of outboard
motor(s):
1
Prepare separate fuel container for pre-
mixing.
30L
WARNING
ENOF01709-0