Troubleshooting - SICE S 1000 Manual De Instrucciones

- Clean and lubricate the upper and lower trolley
guide (Fig. 51c):
Clean with environmentally-friendly solvents and
lubricate with LIPLEX EP 2 lubricant or equivalent.
To carry out every two months.
- Check operation of the stop button (Fig. 51d):
If operating properly, the stop button will appear
on the display.
Otherwise, contact technical assistance.
To carry out every two months.
- Contact the service network to check the belts and rubber pads:
Periodic check by the service network.
To carry out every 7000 wheels
- General machine check, contact the service network:
General periodic check by the service network.
To carry out every year
In the event of a temporary mains power loss with the MOUNTING/DEMOUNTING tool
between the wheel and the tyre, proceed as follows once mains power has been restored:
- Restart the machine
- Press the RESET button on the display
The machine resumes operation normally from
where it was stopped, remembering the position
of the tools and wheel.
In the event of a prolonged electrical power out-
age, the wheel may be released manually by in-
serting an 8 mm diameter steel pin in the relative
hole and turning anticlockwise (see Fig. 52)
ERRORS LIST
E2 Communication software error
Check serial connection between P3K
E17
and board
E19 Pump motor protection
E20 Perform machine calibration
User manual S 1000
8. TROUBLE SHOOTING
SOLUTION
Press OK to restart
Contact support service
51d
UK
52
167