Pre-Use Checks; Preliminary Checks; During Use - SICE S 1000 Manual De Instrucciones

• The employer must ensure that no employees work on wheels unless they have received suit-
able training regarding the correct maintenance procedures for the type of wheel being serviced
and the relative safety procedures, and are specifically appointed to do so.
• Information to be used in the training programme shall include, at a minimum, the applicable
information contained in this manual.
2. The employer is required to ensure that all employees meet the requisites for working safely
on wheels, which includes the following activities:
• Demounting tyres (including deflation).
• Inspecting and identifying rim wheel components.
• Tyre mounting.
• Using any restraining device, cage, barrier, or other installation.
• Handling rim wheels.
• Tyre inflation.
• Keep away from the tyre changer while inflating the tyre and do not lean over the wheel when
inspecting the wheel after inflation.
• Wheel installation and removal.
3. The employer shall evaluate each employee's ability to perform these tasks and to service rim
wheels safely, and shall provide additional training as necessary to assure that each employee
maintains his or her proficiency.

1.6. PRE-USE CHECKS

Before beginning work, carefully check that all components of the machine, especially rubber or
plastic parts, are in place, in good condition and working properly. If the inspection reveals any
damage or excessive wear, no matter how slight, immediately replace or repair the component.

1.7. DURING USE

In the event you hear any strange noise or feel unusual vibration, if a component or system is not
operating properly, or if there is anything unusual at all, stop using the machine immediately.
• Identify the cause and take any necessary remedial action.
• Contact your supervisor if necessary.
Make sure that all other people are positioned at least 6 metres (20 feet) from the machine.
To stop the machine in an emergency:
• disconnect the power supply plug;
• interrupt the compressed air supply by disconnecting the supply pipe.
User manual S 1000
114