With The Gate Closed Permits Opening With Ft1 Obscured; Mode If Photocell Ft2 Is Interrupted When Opening; Mode If Photocell Ft2 Is Interrupted When Closing; With The Gate Closed It Permits Opening With Ft2 Obscured - Roger Technology B70/1DC Instrucciones Y Advertencias Para El Instalador

52 01

With the gate closed permits opening with FT1 obscured

00
does not permit opening
01
permits opening
02
OPENS WHEN IT IS OBSCURED
53 03

Mode if photocell FT2 is interrupted when opening

00
IGNORE, no action or FT2 not installed
01
STOP, the gate remains stationary until the next command
02
REVERSE IMMEDIATELY, thus closing
03
TEMPORARILY STOP, the beam released, it continues to open
04
INVERT WHEN RELEASED, the beam released, it reverses thus closing
54 04

Mode if photocell FT2 is interrupted when closing

00
IGNORE, no action or FT2 not installed
01
STOP, the gate remains stationary until the next command
02
REVERSE IMMEDIATELY, thus closing
03
TEMPORARILY STOP, the beam released, it continues to open
04
INVERT WHEN RELEASED, the beam released, it reverses thus closing
55 01

With the gate closed it permits opening with FT2 obscured

00
does not permit opening
01
permits opening
02
OPENS WHEN IT IS OBSCURED
56 00

With the gate completely open, recloses 6 seconds after photocell interruption

00
OFF (photocell interruption does nothing)
01
the interruption of FT1 causes the closure
02
the interruption of FT2 causes the closure
NOTE: the parameter is not visible if you set parameter
65 05

Stop space when braking

01 05
1 = quick brake/minimum stopping distance ... 5 = gentle braking
-
71 01

Position of the motor with respect to the gap

00
motor positioned on the LEFT with respect to the gap looking from the inside
01
motor positioned on the RIGHT with respect to the gap looking from the inside
NOTE: parameter
0-
in simplified mode
a8 03 04
to or .
35