entrematic Ditec TOP603H Manuale Tecnico página 79

Menu
Auxiliary card
0= without TOP905AC
1= with TOP905AC
Relay 1 (with auxiliary card TOP905AC) if A9 = 1
0= no function
1= electric lock (activated for 1 s at each start)
2= flashing light (activated when the motor is moving)
3= photocell test (transmitter voltage interrupted)
4= door OPEN (activated with door fully open)
5= door CLOSED (activated with door fully closed)
6= green light (activated with door fully open)
7= red light (deactivated with door fully open)
Relay 2 (with auxiliary card TOP905AC) if A9 = 1
0= no function
1= electric lock (activated for 1 s at each start)
2= flashing light (activated when the motor is moving)
3= photocell test (transmitter voltage interrupted)
4= door OPEN (activated with door fully open)
5= door CLOSED (activated with door fully closed)
6= green light (activated with door fully open)
7= red light (deactivated with door fully open)
Closing edge protection (with auxiliary card TOP905AC)
0= disabled
1= optic edge FUTURE USE
Detection of stroke with little weight / friction
0= door with little weight / low friction
1= door with standard weight / normal friction
Selection of automatic closure
0= disabled
1= 10 sec
2= 30 sec
3= 1 min ... 5 = 3 min
6= 5 min ... 8 = 15 min
With automatic closure enabled, the OPEN/STOP/CLOSE/STOP
command becomes a simple OPENING command.
The enabling of automatic closure is visualised on the display
with (point) flashing with the door open, or fixed after a
step-by-step STOP command.
The step-by-step STOP commands given when automatic
closure is enabled are not permanent.
DO NOT USE
Maintenance alarm
0 = disabled
1..9 (1000 door operations)
Example: 5 = 5000 door operations
When the maintenance interval has expired, the courtesy light
flashes after every movement.
A new maintenance alarm setting will reset the counter.
Function, setting range, unit
79
Factory
Value
settings
0 - 1
0 - 7
0 - 7
0 - 1
0 - 1
0 - 8
0 - 9