Self-Learning Of The Stroke Top903H - entrematic Ditec TOP603H Manuale Tecnico

21. Self-learning of the stroke TOP903H

WARNING: when an automation stroke self-learning operation is carried out, the obstacle detec-
tion device is not active.
NB: the self-learning operation can only be carried out during the initial installation or following
an automation RESET. Do not press any keys during this procedure.
1. Turn on the power supply.
• The display flashes L4.
• Press and hold the [7] button. The door will open.
• The display flashes L4.
• Release the button when the required opening position is reached.
• Use the [5] button to correct the position if necessary.
• The courtesy light flashes 4 times during operation L4.
2. Press the [6] button. The display flashes L3.
• The automation memorises the opening position and begins a closing operation.
• The courtesy light flashes 3 times.
• When the door reaches the closed position, the display flashes L2. The courtesy light flashes
twice.
• The automation opens automatically as far as the open position. The display flashes L1. The
courtesy light flashes once.
• The automation automatically recloses as far as the closed position, the display visualises
and the door re-opens. The lamp does not flash.
C
3. The self-learning procedure is complete when the door is open and the courtesy light is ON.
NB: in certain cases, especially when the door moves very smoothly or the traction unit is not
connected to the door, the automatic stroke self-learning procedure may fail. This brings the
procedure back to the initial display condition L4.
In this situation, you must modify parameter b3 = 000 (see ch. 23-24) to guarantee the correct
memorisation of the stroke.
Self-learning of the stroke with a remote transmitter
When the automation is delivered or reset, the remote transmitter assumes the following func-
tions:
• (1) has the same function as (UP arrow)
• (3) has the same function as (DOWN arrow)
• (2) or (4) has the same function as
For the self-learning of the stroke, refer to the procedure explained above.
Once the self-learning phase is complete, key [1] is used to command the door. The other keys can
be used to command other similar automations or other radio receivers.
(confirm/memorisation)
86
1 2
3 4