Alarms; Self-Diagnosis - entrematic Ditec TOP603H Manuale Tecnico

25.1 Alarms

Self-diagnosis

After the learning procedure, after every motor start-up and after every 2.25 hours in the idle
state, the system performs a self-diagnosis test.
No error =
A
TOP603H error messages
2 EEprom data
3 Current measurement
4 Photocell hardware
5 Switch-off thyristors
6 Switch-off relay
7 Watchdog test
8 ROM test
9 RAM test
If an alarm occurs, perform a RESET (see chapter 14.1 or 20.1).
NB: if the same error occurs in two successive self-diagnosis tests, the control system will be
disabled (commands are rejected).
After about 1 minute, the system performs another self-diagnosis test.
If no errors are detected, the control system is enabled again.
If the error persists, perform a RESET of the factory settings (see chapter 14.2 or 20.2).
All the settings are deleted and the factory values are restored.
Launch a new learning procedure (see chapter 15 or 21) and make the new parameter adjust-
ments (see chapter 18 or 24).
If the problem persists, contact Technical Service.
B C
A
TOP903H error messages
002 EEprom data
003 Current measurement
004 Photocell hardware
005 Switch-off thyristors
006 Switch-off relay
007 Watchdog test
008 ROM test
009 RAM test
010 SE test
94
B C