Memorising / Deleting Remote Controls - entrematic Ditec TOP603H Manuale Tecnico

22. Memorising / Deleting remote controls

22.1 Memorising remote controls via the control panel
1. Press the [7] and [5] keys simultaneously for about 1 s. The display flashes
2. Select the required function with the [7] and [5] keys.
• The display indicates
• Press the required key on the remote control.
• The display indicates
• The function of the memorised key is:
F0 = OPEN-STOP-CLOSE-STOP
F1 = OPEN-STOP-OPEN-STOP
F2 = CLOSE-STOP-CLOSE-STOP
F3 = STOP
F4 = PARTIAL OPENING
F5 = COURTESY LIGHT ON or RESTART SWITCH-ON TIME
F6 = COURTESY LIGHT ON/OFF
F7 = OPEN
F8 = CLOSE
NB: with automatic closure enabled (parameter b4), the
operation and the STOP of the other functions is not permanent.
22.2 Memorising remote controls from a distance
1. Press the PRG of a previously memorised GOL4 transmitter for 5 seconds
(within the range of the receiver) until the LED lights up.
2. Press any one of the CH keys of the new transmitter.
• The new transmitter can memorise the same keys as the existing trans-
mitter.
NB: be careful not to accidentally memorise your neighbours' transmitters.
22.3 Deleting remote controls
1. Press the [7] and [5] buttons simultaneously for more than 6 seconds. The display flashes
, first slowly and then more quickly.
•
All the remote controls are deleted.
22.4 Checking the radio reception level
The level of radio reception received can be visualised:
• Press the [7] and [5] keys simultaneously for about 1 s. The display flashes
• Press the [7] and [5] keys simultaneously again for about 1 s to see the radio level.
x = 0 no radio signal ... x = 8 high radio level
The visualisation of the radio level is deactivated when the two keys, [7] and [5], are pressed
again for about 1 s.
-
- for about 1 s, and the remote control is memorised.
87
function activates an OPENING
PRG
.
.