Adjusting The Parameters - entrematic Ditec TOP603H Manuale Tecnico

23. Adjusting the parameters

1. Press the menu button
or to the last parameter adjusted. The 2-character menu name flashes. For example, A0.
2. Select the required parameter using the [7] and/or [5] buttons.
3. Press the menu button
parameter. For example, 000.
4. Alter the value using the [7] and/or [5] buttons. The new value is automatically memorised.
5. Press the [6] button for less than 1.5 s. The display returns to the selected parameter.
• To quit the adjustment mode, press the
• The adjustment mode is automatically quit after 15 s of inactivity.
NB: while the adjustment mode is active, the automation cannot accept any commands.
WARNING: if the programming menu values from A0 to A4 are modified, the display visualises
L4 and you must repeat the learning procedure (see chapter 21).
[6] for more than 1.5 s. The display goes to the adjustments menu
[6] for less than 1.5 s. The display indicates the value of the selected
[6] button for more than 1.5 s.
88