Wiring The Accessories - entrematic Ditec TOP603H Manuale Tecnico

19.1

Wiring the accessories

There are two ways to connect the TOP operator to the stop and open commands and the
photocells:
1. By using pre-wired cables (ref. TOP905CAB1, TOP95CAB2, TOP905CAB3, TOP905CAB4),
not included in the operator kit.
2. By using made-to-measure cables.
19.1.1 Pre-wired cables
For pre-wired cables, follow the instructions below:
TOP905CAB1 (10 m)
WARNING: use EXCLUSIVELY for the STOP command.
TOP905CAB2 (10 m)
TOP905CAB2 (10 m) + TOP905CAB3 (13 m)
TOP905CAB4 (10 m)
- STOP command
Yellow
Green
Black
- OPEN command for powered accessories
Yellow
Green
Black
TOP905CAB2
Yellow
Red
Green
Black
- OPEN contact for NON-powered accessories
Yellow
Green
Black
82
24V
Red
+24V
Red
-0V
- Connection of PHOTOCELLS
RX
TOP905CAB3
24V
Yellow
Black
0V
Red
TX
24V
0V