Level 1 Setting; P01 - Grava (Enroll) - Nice ANATEL Guarita IP Instrucciones Y Advertencias Para La Instalación Y El Uso

PROGRAMMING KEY
Image 9.1.b
Image 9.1.a

10. LEVEL 1 SETTING

10.1 P01 - GRAVA (ENROLL)

NOTE: After any inclusion of a new device or some change in the device register, turning the
programming key to the OFF
the sync, will be displayed the answer received from each Receiver: TX (remote control),
CT (proximity card / biometry / password), TA (active Tag) and TP (passive Tag / UHF).
If in some position appear the letter "F", it means that the correspondent receiver was not
updated correctly. Verify the receiver and the connections, and then try again.
To register a new device in the system, first, insert the device serial number, except to the
access password and fingerprint registration. There are two ways to register the devices. Using
new devices mode through the "P01 – Grava (Save)" function and select the device type
(controle (control), Tag ativ. (active Tag), cartão (card), senha (password), biometria
(fingerprint) or Tag pass. (passive Tag)). Also, a fast registration mode can be used. For this,
turn the programming key to the ON position and in the fast registration screen add the device
as described in the item 10.2
FAST REGISTRATION SCREEN
Note: Turning the device on (power-up), with the
programming key in the "ON" position, information as
verification of receivers, total of events, presence of
internal SD Card, Voice, HTML, RS-232 baud rate,
connection and CAN baud rate will be displayed.
Image 9.1.c
position, the system will ask for Receiver Syncronization. During
.
P01 SCREEN – GRAVA (ENROLL)
Image 10.1.a
Image 10.1.b
Português - English - 117
117