Nice ANATEL Guarita IP Instrucciones Y Advertencias Para La Instalación Y El Uso página 131

BAUDRATE CAN
Data baud rate setting for the CAN line, factory standard =
125kbps, image 11.6.b. If necessary adjust the communication with the
receivers connected to the system during the "Atualizar Receptores
(Receiver sync)" operation, the baud rate can be adjusted to 20kbps
(smaller baud rate for wide cable), and the receiver must also be
adjusted with the same parameters (consult the receiver manual).
To change baud rate setting, access the "A06 – Baud rate" option,
image 11.6.c, set the desired parameters and press ENTER again
to save the programming.
11.7 A07 - OPÇÕES (OPTIONS)
DUPLA PASSAGEM (Double pass)
Activating this function on the "Multifunção" Receiver, every performed activation by a device
(TX, CT, Active or Passive TAG) considers that only one vehicle may pass through the
sensor (inductive loop or photocell) installed near to the access gate or barrier gate and
connected to the receiver. If pass more than a vehicle (hitchhiking), the Guarita IP will sound
an audible alert and it will display the "Dupla passagem – Double pass" message, storing
the event in the internal memory.
BUZZER
Enable or disable the sound alert, after any activation of any device or also performing a
Guarita IP operation (normal mode only).
SOBREPOR MENSAGEM (Overlap Message)
If this function is enabled, always that a device is activated, the information will be displayed
on the Guarita IP screen, and if there is another activation after the previous one, the
displayed message will be overlapped with the information of the second activation.
CONTROLE DE VAGAS (Parking Spaces Control)
Enabling this function in the "Multifunção" Receiver (in remote control mode), the option of
parking spaces control without software will be activated (parking spaces control by device.
Consult us).
OPÇÃO VAGAS (Parking Space Option)
− SEM VALIDAÇÃO (Without Validation)
When an activation is performed (example: Entrance), the parking space will be filled even
if there is not any pass through sensors (inductive loop or photocell) installed near the
access gate or barrier gate.
Image 11.6.b
Image 11.6.c
Português - English - 131
131