Device Data Registration - Nice ANATEL Guarita IP Instrucciones Y Advertencias Para La Instalación Y El Uso

10.2.7 DEVICE DATA REGISTRATION

After linking the device serial to the system, will appear the message
Grava (Enroll), image 10.2.7.a.
The cursor will be flashing over the first number of the Apartment
(Apto:0000). Set it and if there are more than a tower, select it in
sequence (BL.: A). For example, to select the number 11 to the
apartment, advance the two first numbers and insert the number 1 on
the third and fourth field, visualizing 0011, image 10.2.7.b.
In the third line there are the 8 receivers that the system can have:
RF (controle remoto - remote control), TA (Tag ativo – active Tag), CT
(cartão – card / chaveiro de proximidade – 125 kHz card) or TP (Tag
passivo – passive Tag). Remember that before register a device it is
suggested verifying
correspondent "N" to the receiver that the device will be registered
and change to "S" (SIM), image 10.2.7.c.
in the fourth line, a device identification can be inserted with up to 18
characters (E.g.: NORBERTO BRITO), image 10.2.7.d.
After inserting this information and press the ENTER key, the second
registration screen will be displayed, image 10.2.7.e.
In this screen insert the vehicle brand, color and plate with seven
characters, using a USB keyboard or the Guarita IP panel, image
10.2.7.f. After inserting this information, press ENTER. If the "Grupos
(Groups)" option, 11.16, is enabled, a third registration screen will be
displayed, image 10.2.7.g.
Select the desired group to link the device to the group. Otherwise,
select the "Não (No)" option, image 10.2.7.g / image 10.2.7.h. After
set, press the ENTER key to complete. A confirmation message will
be displayed, image 10.2.7.i, press ENTER again, and the device
will be registered correctly, image 10.2.7.j.
Continue with the registration of the other devices.
Finishing the registration of all devices, turn the programming key off,
image 9.1.a, and the message "Memória Alterada! Deseja Atualizar?
(Memory updated! Do you want to sync?)" will appear, image
10.2.7.k, press ENTER. Then, the memory data of the receivers
connected to the system will be updated, image 10.2.7.l. Wait until
the "Atualização feita com sucesso (Updated successfully)" message
be displayed, image 10.2.7.m. Then, will be displayed the "Backup
automático (Automatic Backup)" message, image 10.2.7.n, with the
countdown of 5 seconds. To cancel the backup press ESC before the
countdown finishes (finishing the countdown the backup will happen
automatically); to confirm the backup, press ENTER. "Aguarde...
Backup automático (Wait... automatic backup)" message will be
displayed, image 10.2.7.o, indicating that a backup of all Guarita IP
data is being performed in the internal SD Card, image 3.1.a Ref. 10.
The data contained in this backup can be used for recovery, if some
damage occur to the (EEPROM) internal memory. After this, the
devices will be successfully registered.
the destination receivers. Select the
Image 10.2.7.a
Image 10.2.7.b
Image 10.2.7.c
Image 10.2.7.d
Image 10.2.7.e
Image 10.2.7.f
Image 10.2.7.g
Image 10.2.7.h
Image 10.2.7.i
Image 10.2.7.j
English - 120
Português -
120