Nice ANATEL Guarita IP Instrucciones Y Advertencias Para La Instalación Y El Uso página 138

11.15 A15 - BIOMETRIA (BIOMETRICS)
Through the "A15 – Biometria" menu is possible visualize the
firmware version of the connected biometric equipment, 4.6, define
if the user can register a second fingerprint, if the second
fingerprint will send a panic signal or will make a common
activation, and allow delete all the registered fingerprint.
To change the fingerprint setting, access the "A15 – Biometria" option,
image 11.15.a, select the desired parameter, image 11.15.b, press
ENTER, redefine the parameter and press ENTER again to save the
setting.
NOTE: The "QUALIDADE MIN." parameter refers to the minimum
quantity of necessary valid points to perform new registrations. The lower
the percentage, the less points and the greater the chance of errors in the
validation (less secure). The greater percentage, the more points and the
less chance of validation errors (more secure).
The options after Qualidade Min. - Minimum Quality, demonstrates the
setup of each one of the 4 biometrics connected to the RS485 of each
one of the 8 Multifunction Receivers 4A that can be connected to the
Guarita IP.
- Versao FW: Firmware version of the Biometric Controller;
- Senha LAN: Code for TCP/IP communication (no use);
- Sleep Tela: Time in seconds to hibernate the Biometric Controller screen display screen;
- Volume: Sound level of the Biometric Controller keys [0 to 5];
- Idioma: Language of the Biometric Controller menus (read only) [English, Spanish, Portuguese
and Russian];
- Form Data: Date (display) format [DDMMAA - DDMMYY, AAMMDD - YYMMDD, MMDDAA -
MMDDYY];
- Form Hora: Hour (display) format [24 hs, 12 hs AM/PM];
TipoAcesso: Access event format [0 to 15, where 0 = Entrada – Entrance /1 = Saída – Exit /2
-
= Pausa – Interval /3 to 15 = Pre-defined];
- PrecisaoAces: Accuracy of digital validation [Baixa - Low, Média - Medium and Alta - High];
- Cod.Fixed Wieg: Fixed Wiegand code [0 to 254];
- Saida Wieg: Biometric Controller Wiegand output [w26, Anviz, fixed, Linear];
- Cod. Trabalho: Enable "Fn" key of the Biometric Controller;
- Modo Real-Time: Enable Real-Time mode to TCP/IP communication;
- Atual. Digital: Enable the intelligent update of the fingerprint during the validation;
- Modo Rele: Biometric Controller relay operation [Acesso - Access, Alarme - Alarm];
- Tempo Rele: Time in seconds of relay activation [0 to 15];
- Alerta MemEvt: Events full memory alarm [0 to 5000 remaining events];
- AcessDelay: Time in minutes to ignore the event of the same access [0 to 250];
- Sensor Porta: Time in seconds of the Biometric Controller open door alarm [0 to 250];
- Prog. Alarme: Time in seconds of the programmable alarm [0 to 15];
- Calib.Relogio: Time in seconds of the clock offset [-60 to +60];
- Ajust.Dedo Umido: Wet finger adjustment [0 to 8].
Image 11.15.a
Image 11.15.b
English - 138
Português -
138