Tabla de contenido
Publicidad
STORAGE
immediately prepare your snow thrower for storage at the end of the season or if the unit will not be used for 30 days or more.
WARNING: Never store the snow thrower with gasoline in the tank inside a building where fumes may reach an
d_t open flame,
or
as on a furnace, water heater, clothes
Allow the
to
spark
pilot tight
dryer
or
gas appliance.
engine
coolbeforestoring inany enclosure,
@
Snow thrower
When snow thrower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc Store in a clean,
dry area
I
Clean entire snow thrower (See "CLEANING" in the Maintenance section of this manual)
2.
inspect and replace belts, if necessary (See '3"0 REPLACE BELTS" in the Service and Adjustments section of this manu-
al)
3,
Lubricate as shown in the Maintenance section of this manual,
4
Be sure that all nuts, bolts, screws, and pins are securely fastened inspect moving parts for damage, breakage and wear,
Replace if necessary
5
Touch up all rusted or chipped paint surfaces; sand lightlybefore painting
ENGINE
See engine manual
Fuel system
I
Drain the rue! tank
2.
Start the engine and let it run until the fuel lines and carburetor are empty
•
Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur,
•
Use fresh fuel next season
Engine oil
Drain oil (with engine warm) and replace with clean engine oil (See "ENGINE" in the Maintenance section of this manual)
Cylinder
t
Remove spark plug.
2
Pour one ounce (29 ml) of oil through spark plug hole into cylinder
3
Pull recoil starter handle slowly a few times to distribute oil
4
Replace with new spark plug
OTHER
•
Remove safety ignitionkey; store in a safe place.
•
Do not store gasoline from one season to another.
•
Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline wil! cause problems.
•
If possible, store your snow thrower indoors and cover it to protect it from dust and dirt
•
Cover your snow thrower with a suitable protective cover that does not retain moisture Do not use plastic. Plastic cannot
breathe, which allows condensation to form and will cause your snow thrower to rust,
IMPORTANT: Never cover snow thrower while engine/exhaust area is still warm
LAGERUNG
Machen Sie lhre Schneefr_se sofort gen Ende der Saison lagerfertig, oder wenn Sie das Ger&t 30 Tage oder I&nger nicht be-
nutzen werden
WARNUNG: Lagern Sie die Schneefr&se bef gefi_lltem Benzintank nie in einem Geb_ude, in dem die Benzind_mpfe
an eine offene Flamme, eine Z_ndvorrichtung oder Z£mdflamme wie an einem Gasherd, eln HeiBwasserger_t, einen
W&schetrockner oder eln gasbetrlebenes Ger_t getangen k6nnten_ Lassen Sie den Motor zun_chst abk_hlen, bevor
Sie das Ger&t in einem geschiossenen Raum lagern,
Schneefr ise
Soil die Schneefr&se Liber einen t&ngeren Zeitraum gelagert werden, so reinigen Sie sie sorgf<igst
Entfemen Sie jeg_ichen
Schmutz, Schmier61, B]&tter, usw Lagern Sie das Ger&t in einem sauberen, trockenen Bereich
53
Publicidad
Tabla de contenido
