ANTEO FUTURA F3 RE Uso Y Mantenimiento página 163

Parts not painted
Plates indicating loads, capacities
and warnings
Oil level
Platform clearance lights
The entire machine
Controls
Two-switch controls
Moteur électrique
"Power on" green pilot light
(*) to be done at an Authorised ANTEO Centre.
Parts not painted visual – to locate possible oxidation points.
Plates indicating loads, capacities visual - (these must ALWAYS be perfectly LEGIBLE and VISIBLE from all control positions).
and warnings
Oil level check the oil level in the tank with the platform resting on the ground. Refill if necessary (see Par. "Hydraulic fluid refilling") Monthly
Platform clearance lights visual – if mounted, turn on the main ignition switch and check that they flash.
The entire machine visual – perform any possible movement to locate anomalies.
Controls functional– to discover any jams, hardening or false contacts.
Two-switch controls functional– movement must NEVER be obtained using only a single switch.
Moteur électrique visual - inspect the motor brushes and clean using compressed air (*).
"Power on" green pilot light switch on the main ignition and check that the pilot light comes on.
(*) to be done at an Authorised ANTEO Centre.
visual – to locate possible oxidation points.
NOTE: corrosion must NEVER exceed a depth of 0.02 in.
visual - (these must ALWAYS be perfectly LEGIBLE and VISIBLE from all control positions).
check the oil level in the tank with the platform resting on the ground. Refill if necessary (see Par. "Hydraulic fluid refilling") Monthly
visual – if mounted, turn on the main ignition switch and check that they flash.
visual – perform any possible movement to locate anomalies.
functional– to discover any jams, hardening or false contacts.
functional– movement must NEVER be obtained using only a single switch.
visual - inspect the motor brushes and clean using compressed air (*).
NOTE: replace the brushes if they have a thickness less than 0.28 in.
switch on the main ignition and check that the pilot light comes on.
NOTE: corrosion must NEVER exceed a depth of 0.02 in.
NOTE: replace the brushes if they have a thickness less than 0.28 in.
En
En
Every three months
During use
During use
During use
During use
During use
Every three months
During use
159
Every three months
During use
During use
During use
During use
During use
Every three months
During use
159