ANTEO FUTURA F3 RE Uso Y Mantenimiento página 188

The platform does not lift the entire load.
The tip of the platform does not tilt towards the ground.
The platform stops while going up or down using the foot
control.
Some points on the faults table require special skills and specific knowledge.
If in doubt about any point, STOP the check and consult ANTEO S.p.A. before proceeding.
184
The platform does not lift the entire load.
The tip of the platform does not tilt towards the ground.
The platform stops while going up or down using the foot
control.
Some points on the faults table require special skills and specific knowledge.
If in doubt about any point, STOP the check and consult ANTEO S.p.A. before proceeding.
184
En
Load too heavy or load center of gravity exceeded.
Suction filter clogged.
Faulty pump.
VM1 pressure relief valve poorly adjusted or faulty.
The tilt switch does not activate the tilt cylinders valves.
Platform table cut-off.
En
Load too heavy or load center of gravity exceeded.
Suction filter clogged.
Faulty pump.
VM1 pressure relief valve poorly adjusted or faulty.
The tilt switch does not activate the tilt cylinders valves.
Platform table cut-off.
Check the load.
Observe the load diagram.
Replace filter.
Replace the pump.
Detect the pressure via a pressure gauge and adjust the
valve.
Replace if necessary.
Check and, if necessary, replace the tilt switch.
Repair or replace the cable.
Check the load.
Observe the load diagram.
Replace filter.
Replace the pump.
Detect the pressure via a pressure gauge and adjust the
valve.
Replace if necessary.
Check and, if necessary, replace the tilt switch.
Repair or replace the cable.